2019 started with a bang!
In January The Happy Project delivered packs of stationary to our support school Wysersdrift Primary. We had a stationery drive which ran throughout 2018 in which we managed to collect a lot of stationery which was unwanted or donated. We then took all the stationery we had collected and repackaged it all neatly so that it could be delivered to Wysersdrift and be put to good use.
Wysersdrift Primary is a farm school on the outskirts of Worcester, Western Cape. There are currently 193 students spanning from Gr R to Gr 6. Although the school is a happy place to be and the students love attending their school, Wysersdrift could do with a lot of help building the school to be a better and safer place. If you would like to get involved please get in touch! Every little bit helps!!
Operating a loader, or any other type of machine can be a dangerous activity if certain guidelines are not followed. A good understanding of working environments and machine capabilities is critical for safe operation.
Listed below are guidelines to follow before, during and after operating a loader (N.B. not all inclusive; always refer to operation and maintenance manual for complete instructions).
Before operating the loader:
- Obtain a pre-shift checklist if available and complete it accurately. It is important to always record the results of inspections.
- Review the operation and maintenance manual before operating; know the safety precautions.
- Inspect the condition of the tires or track shoes for excessive wear, cracks and bulges.
- Verify all fluids are at the right levels.
- Inspect the condition of the bucket, nuts, bolts and other wear items for cracks or damage.
- Verify that there are no rocks, debris or other material that could fall back into the cab.
- Always wear the proper personal protective equipment for the job. Some applicable forms of PPE include; leather gloves, protective helmets, eye and ear protection and steel toe boots (make sure work boots have good tread).
- Use caution accessing and exiting the cab of the machine; maintain three points of contact at all times.
- Verify all gauges are working properly and the inside of the cab is ready for safe use.
Operating the loader:
- Always wear a seat belt and honk horn before moving the loader.
- In cold conditions, start the engine and let it run at idle speed for 15 minutes before operating; exercise the bucket up and down a few times to warm the hydraulic oil.
- Never exceed speed limits and do not make sharp turns or aggressive moves.
- Never operate on an incline with the load in the raised position (doing so could results in tipping the load or loader).
- Do not exceed the rated loads for the equipment; always attempt to center the load to the bucket when loading and unloading.
- Always be aware of surroundings – Use a spotter and know where pedestrians, objects, overhangs, fall hazards, uneven conditions and other vehicles are at all times.
After operating the loader:
- Let the loader run at idle speed for 5 minutes before completely shutting down.
- Lower the bucket to ground to avoid stress on hydraulic systems.
- Clean the loader off with high pressure water before any mud or debris hardens.
- Inspect and verify the same items before you operated the loader (see above).
- Shut off the engine before refueling.